EC220 access control does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EC220 access control does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

interrupt

2022-07-12 19:44:45

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-07-12

EC220 access control does not work

2022-07-12 19:44:45

Tags:

Model: Archer C80

Hardware Version: V5

Firmware Version: EC220-G5 v2 00000002

My ISP installed a EC220-G5 on my network. It's connected to a fiber optic modem/route in bridge mode.

I configured the wireless access control in Advanced > Security > Access Control. Set it to Enabled, and Access Mode to allow devices. Then registered all MACs.

Still, a TV that I had configured on this network continues to be able to connect even after rebooting the router and the TV. It's like the access control is doing nothing.

Any advice?

PS.: I can't find EC220-G5 in the model list.

1 Reply

terziyski

LV7

2022-07-12 23:38:47 - last edited 2022-07-13 00:46:33

Posts: 7129

Helpful: 5340

Solutions: 1207

Stories: 7

Registered: 2013-10-12

Re:EC220 access control does not work

2022-07-12 23:38:47 - last edited 2022-07-13 00:46:33

@interrupt

EC220-G5 v2 is an ISP tailored device. You should contact your ISP to resolve this issue.

That's why you can't find the EC220-G5 v2 in the models list.

Although, you can check in your TV network settings, which is the wireless network(device) it's connected to and confirm that's indeed the EC220-G5 v2.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

EC220 access control does not work

EC220 access control does not work

Information

Voters 0

Tags