Archer vr400 as access point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I configured the router according to these steps:
1. go to plan setting set IP 192.168.0.12 (match the subnet of the main router which is er605 by tplink)
2. configure my wireless networks
3. disable dhcp server and reboot
4. connect lan port on main router to plan port on vr400 which is now an access point
now from my machine when I connect to 192.168.0.1 it goes to er605
and 192.168.0.12 leads to vr400
so far all ok
1. when i log into vr400 on the diagram there i see internet NOT connected, but internet is connected - anyway to fix it?
2. 5Ghz wireless works fine when i connect, i can see on my phone that it say 866Mbps, but then it drops after a few mins/secs to 6Mbps and say connected no internet - i have the latest firmware, anyway to fix it? the distance from the router is around 3-4 meters
