BldgAdm wrote

I would like your assistance to daisy chain 4 units of Archer AX 10 from my modem. The distances from each unit is about 30 meters (2 units are on the 5/F floor, and another 2 units are on the 6/F)

1) Should the first AX10 connected via cat6 from my modem have a cat6 inserted into the WAN Port (of this 1st AX 10 unit named ALPHA. For purposes of this query, I will name the 4 AX 10 units as ALPHA, BRAVO, CHARLIE, DELTA).

2) Then should I insert from one of the LAN ports of the ALPHA,  a cat6 cable and insert it into the WAN port of BRAVO.

3) Then should I insert from one of the LAN ports of the BRAVO,  a cat6 cable and insert it into the WAN port of CHARLIE.

4) And should I insert from one of the LAN ports of the CHARLIE,  a cat6 cable and insert it into the WAN port of DELTA.

5) And my final question is should I also configure the 4 AX 10 units into AP modes?

 

Your guidance is very much appreciated. 

 

Thank you,

BldgAdm

  @BldgAdm 

1) Yes

2) Yes

3) Yes

4) Yes

5) Yes given your modem is doing NAT already (i.e. modem/router). If it's just a pure modem then only the ALPHA should be in wireless router mode.

Here's the AP mode gude - use Case 1.