Home Network Community > Deco > Deco topologies supported?
< Deco

Deco topologies supported?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco topologies supported?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco topologies supported?
Deco topologies supported?
2022-03-16 06:30:06 - last edited 2022-03-17 01:29:57
Model: Deco M4  
Hardware Version: V6
Firmware Version:

Hello!

 

I am about to get a deco 3 pack, I am wondering if the following topologies are supported.

 

1. All Decos in AP mode (having same SSID WiFi mesh) and using them to connect a switch.

 

 

2. One Deco as main router, other 2 as AP connecting switch to it, (having same SSID WiFi mesh in the 3 Decos)

 

 

Is this supported? I am trying to accomplish deco´s wired to have best WiFi performance but using extra LAN port to connect different wired device using a switch.

 

Any comment will be appreciated it.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Deco topologies supported?-Solution
2022-03-16 09:24:02 - last edited 2022-03-17 01:29:57

  @iWarSam 

 

Both configurations should be possible according to this FAQ - General questions about Ethernet Backhaul feature on your Deco

You should be cautious when choosing the switches:

Some D-Link switches will not forward packets based on IEEE 1905.1 protocol, causing all Deco units in a network loop and becoming quite unstable.

Here some additional guides:

Can I use Deco with my existing router?

How to set up Deco to work in Access Point mode?

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:Deco topologies supported?-Solution
2022-03-16 09:24:02 - last edited 2022-03-17 01:29:57

  @iWarSam 

 

Both configurations should be possible according to this FAQ - General questions about Ethernet Backhaul feature on your Deco

You should be cautious when choosing the switches:

Some D-Link switches will not forward packets based on IEEE 1905.1 protocol, causing all Deco units in a network loop and becoming quite unstable.

Here some additional guides:

Can I use Deco with my existing router?

How to set up Deco to work in Access Point mode?

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 490

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.