Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Best way to connect and use 6 Deco E4 in a 2-3 storey building

< Deco

Best way to connect and use 6 Deco E4 in a 2-3 storey building

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Best way to connect and use 6 Deco E4 in a 2-3 storey building

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

roins

2022-03-10 02:10:38

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-03-10

Best way to connect and use 6 Deco E4 in a 2-3 storey building

2022-03-10 02:10:38

Model: Deco E4

Hardware Version:

Firmware Version:

Hi all,

can anyone suggest the best way to connect and use 6 pieces of Deco E4?

My initial thought was to run cables from all the 6 of the Deco E4 to a switch that is connected to my modem. This way I should be able to obtain a consistent internet speed.

I have not tried it as I will need to purchase the Lan cables etc. Has anyone experienced this before?

Cheers,

1 Reply

Alexandre.

LV6

2022-03-10 16:36:17

Posts: 4063

Helpful: 2376

Solutions: 553

Stories: 0

Registered: 2020-10-22

Re:Best way to connect and use 6 Deco E4 in a 2-3 storey building

2022-03-10 16:36:17

@roins

Three out of my four Deco nodes are wired with Ethernet cables, and that setup works perfectly. The only thing you may need to do is switch Deco mesh to Access Point mode, otherwise you will be more restricted in how you can wire Deco units. Also, not every switch supports Deco mesh Ethernet wiring. See the following TP-Link documents:

General questions about Ethernet Backhaul feature on your Deco

How to set up Deco to work in Access Point mode?

Best way to connect and use 6 Deco E4 in a 2-3 storey building

Best way to connect and use 6 Deco E4 in a 2-3 storey building

Information

Voters 0

Tags