C5400 have serious issue WiFi 2.4GHz

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

C5400 have serious issue WiFi 2.4GHz

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Xarsage1

2022-03-06 11:23:47 - last edited 2022-03-09 09:01:42

Posts: 3

Helpful: 4

Solutions: 0

Stories: 0

Registered: 2019-06-01

C5400 have serious issue WiFi 2.4GHz

2022-03-06 11:23:47 - last edited 2022-03-09 09:01:42

Model: Archer C5400

Hardware Version: V2

Firmware Version: 1.2.5 Build 20210308 rel.64655(5553)

Wi-Fi 2.4GHz having issue, mainly I set this frequency for all my smart devices.

After a while they all disconnected using this firmware 1.2.5 Build 20210308 rel.64655(5553).

When I checked the router the Wi-Fi was not enable and it's off for 2.4GHz.

For 5GHz-1, I turn it off and 5GHz-2 it seem to be fine.

I also try to enabled the Guest SSID with same setting with configuration, it seem doesn't work good either.

I don't know if TPlink support itself know this issue and address it the issue of this router or not.

So many product they release not even one is stable.

Judging by the firmware version itself there no fix until now, very frustrating and very disappointing.

1 Accepted Solution

Kevin_Z

2022-03-09 09:01:35 - last edited 2022-03-09 09:01:42

Posts: 21745

Helpful: 5122

Solutions: 2562

Stories: 21

Registered: 2018-12-24

Re:C5400 have serious issue WiFi 2.4GHz-Solution

2022-03-09 09:01:35 - last edited 2022-03-09 09:01:42

Hello @Xarsage1,

Please try the following troubleshooting suggestions to see if you can make the 2.4G work stably for the smart devices:
1. Modify the 2.4G wireless settings, such as wireless channel, channel width, and security, you can try different combinations. Try to change the 2.4G wireless security to WPA2-PSK TKIP, save and reboot the router to confirm.
2. Schedule the 2.4G wireless, set an off time when there is no need for the connection.
3. Reset the router to factory defaults, reconfigure it from scratch, then monitor the stability.

However, if none of the above helps, it could be a hardware issue and it needs to be replaced, please check the local warranty policy for details or contact the local tech support to be advised further:
https://www.tp-link.com/support/replacement-warranty/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

C5400 have serious issue WiFi 2.4GHz

C5400 have serious issue WiFi 2.4GHz

Information

Voters 0

Tags