Home Network Community > Deco > Solid Red Light on Deco X60
< Deco

Solid Red Light on Deco X60

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Solid Red Light on Deco X60

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Solid Red Light on Deco X60
Solid Red Light on Deco X60
2021-12-06 17:30:03
Model: Deco X60  
Hardware Version:
Firmware Version: 1.5.1 build 202110204 Rel 50164

Found all three of the Deco x60's with red lights after being gone for the weekend. Had to reset all three and create a new network from scratch. One of the three Decos will not connect wirelessly or wired when I connect either of its ethernet ports to a switch. Either way, it goes through the yellow start-up LED for about 2 minutes and then goes back to solid red.

 

Does anyone know of any methods TPLink has to unbrick this? 

 

Thanks

  2      
 
  2      
 
#1
Options
2 Reply
Re:Solid Red Light on Deco X60
2021-12-07 03:02:54

@CloudAdmin 

Hi, just want to confirm one thing, this unit never came to blinking blue after reset, right?

if yes, please refer to this link to run a firmware recovery:

How to use firmware recovery if the Deco become brick

While if the firmware recovery did not work either, please send me a private message about the SN number on this unit.

Thank you very much.

Deco Monthly Recap- Check What's Currently Going on With Deco KidShield Test Recruitment, Share Your Ideas With us! Wi-Fi Schedule Ideas Wanted!
  0  
  0  
#2
Options
Re:Solid Red Light on Deco X60
2021-12-07 13:57:50

@TP-Link 

 

Hi,

 

That is correct. It never achieved a blinking blue light or a solid green light for that matter.

 

When I connected it to a switch on either Ethernet port, the link lights on the switch never lit up.  

 

That being said, the DECO X60 3-pack was purchased at Costco and it's already being returned for an exchange today.

TP-Link wrote

@CloudAdmin 

Hi, just want to confirm one thing, this unit never came to blinking blue after reset, right?

if yes, please refer to this link to run a firmware recovery:

How to use firmware recovery if the Deco become brick

While if the firmware recovery did not work either, please send me a private message about the SN number on this unit.

Thank you very much.

 

Thanks for your reply. 

  1  
  1  
#3
Options

Information

Helpful: 2

Views: 3241

Replies: 2

Related Articles
 Deco X60 Solid Red Light
953 0
Deco X60 blinkg red to green solid in loop...
1101 0
Deco x60 Showing Disconnected but with Solid Green Light
4393 0
 X60 light from yellow to solid red and repeat
355 0
Solid red light
2646 0
 Deco x60 light in red
1844 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.