VX220G2v in bridge mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VX220G2v in bridge mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VX220G2v in bridge mode
VX220G2v in bridge mode
2021-10-29 10:47:46
Model: Archer A10  
Hardware Version: V1
Firmware Version: 2.0.0 0.9 v603c.0 Build 201127 Rel.51511n

Hi everyone,

a quick question: how to set VX220G2V in Bridge mode (voip active)?

Disable DHCP and assign a fix IP (subnet of main router) and what else?

Thanks 

  0      
  0      
#1
Options
3 Reply
Re:VX220G2v in bridge mode
2021-10-29 11:11:40 - last edited 2021-10-29 11:23:44

@BDM 

 

Judging by your description maybe you're trying to set VX220G2v in AP mode ?

If that the case then use this guide - probably you'll have to use Case 2.

 

If you're referring to WDS Bridge feature then use this guide.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#2
Options
Re:VX220G2v in bridge mode
2021-10-30 18:30:28 - last edited 2021-10-31 09:49:18

@terziyski wds bridge isn't an option on vx220.

About case2 (quote) "change the LAN IP address of your TP-Link N router to an IP address on the same segment of the main router. This IP address should be outside the main router’s DHCP range." 

Why not in the DHCP main router range?

  0  
  0  
#3
Options
Re:VX220G2v in bridge mode
2021-10-31 11:23:25

@BDM 

 

That's a suggestion for convenience.

If it is in the DHCP range is possible that the router will give the same IP address to another device (by DHCP) which will cause an IP address conflict.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#4
Options