WDR-4300 resetting configuration
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WDR-4300 resetting configuration
Region : Australia
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.23 Build 121225 Rel.37950n
ISP : Optusnet
Hi there all,
I've had a recent problem where I turn off my router computer etc every night and the next day the router has reset to original configuration. I lose SSID, pasword, region etc and have to do a quick setup or restore a back up config each time.
I've had the unit for about 1 1/2 months and all was ok until recently when I switch the wireless switch at the back of the unit so my kids couldn't access the router and internet. I switched it back on after a while and all was ok and later shut down for the night. The next day when I turned it all on again the SSID password etc had reset.
Not sure if the wireless switching was just a coincidence...
Anyhow I contacted TP-link and was told to disable the WPS for both 2.4Ghz and 5Ghz. That seemed to fix the problem for a couple of days but it has now returned.
Should I try the 30/30/30 reset??
Thanks
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.23 Build 121225 Rel.37950n
ISP : Optusnet
Hi there all,
I've had a recent problem where I turn off my router computer etc every night and the next day the router has reset to original configuration. I lose SSID, pasword, region etc and have to do a quick setup or restore a back up config each time.
I've had the unit for about 1 1/2 months and all was ok until recently when I switch the wireless switch at the back of the unit so my kids couldn't access the router and internet. I switched it back on after a while and all was ok and later shut down for the night. The next day when I turned it all on again the SSID password etc had reset.
Not sure if the wireless switching was just a coincidence...
Anyhow I contacted TP-link and was told to disable the WPS for both 2.4Ghz and 5Ghz. That seemed to fix the problem for a couple of days but it has now returned.
Should I try the 30/30/30 reset??
Thanks
