How to access configuration on TP-Link router set up as an AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to access configuration on TP-Link router set up as an AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

a_23_s

2021-09-02 06:31:12

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-09-02

How to access configuration on TP-Link router set up as an AP

2021-09-02 06:31:12

Title says it all. I've set up a TP-Link Archer C2 as an AP to expand my network. It's connected to my Edgerouter X via a switch. My PC is connected to the Ethernet port on the TP-Link. I set up the router by reseting it and connecting my pc to it and navigating to the default gateway which was 192.168.0.1. Now I am unable to get to the configuration page on the TP-Link. I did not change the default gatway. I've also tried the IP address which I gave the TP-Link to no avail.

<a href="https://applinked.me/">https://applinked.me/</a>

1 Reply

terziyski

LV7

2021-09-02 08:33:40

Posts: 7113

Helpful: 5333

Solutions: 1207

Stories: 7

Registered: 2013-10-12

Re:How to access configuration on TP-Link router set up as an AP

2021-09-02 08:33:40

@a_23_s

Use this guide (Case 2) to configure C2 in AP mode. Set its LAN IP address static so you can access it easily.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

How to access configuration on TP-Link router set up as an AP

How to access configuration on TP-Link router set up as an AP

Information

Voters 0

Tags