Help needed to connect AX3000 to vr1600v

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Help needed to connect AX3000 to vr1600v

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help needed to connect AX3000 to vr1600v
Help needed to connect AX3000 to vr1600v
2021-08-22 07:04:05
Model: Archer AX3000  
Hardware Version:
Firmware Version:

I am hoping someone can provide simple instructions to connect my newly purchased AX3000 router to my existing VR1600v modem router.

I am using wan-wan to connect them. 
The new router does not see the internet
Thanks

  0      
  0      
#1
Options
3 Reply
Re:Help needed to connect AX3000 to vr1600v
2021-08-22 10:29:45

@Dan75 

 

Try connecting VR1600v LAN1 port to AX3000 WAN port (Dynamic IP) and test.

If you are concerned about the double NAT you can put AX3000 in AP mode.

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Help needed to connect AX3000 to vr1600v
2021-08-22 21:19:22
Hi Terzivski Thanks. That is exactly what I found I had to do to resolve. The easy set up manual advised wan - wan connection. Ended up it wasn’t so easy for me 😀 Appreciate the advice.
  0  
  0  
#3
Options
Re:Help needed to connect AX3000 to vr1600v
2021-08-24 11:41:59

@Dan75 

HI, I am glad that the issue has been solved.

But I  am a little curious about the easy setup manual and can I have a picture of the manual you have referred to so that we could check whether there is any misleading information in case of further confusion?

Thank you very much.

  0  
  0  
#4
Options