T6E V1 Not Able To Connect after selecting public or private network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

T6E V1 Not Able To Connect after selecting public or private network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T6E V1 Not Able To Connect after selecting public or private network
T6E V1 Not Able To Connect after selecting public or private network
2021-08-20 07:26:49
Model: Archer T6E  
Hardware Version: V1
Firmware Version:

It has been a while since I used my wireless adapter.  I have been connected to Ethernet. So not sure when the problem would have originated.

 

Windows 10 64Bit

I have removed any old drivers, installed newest windows 10 driver from the website.  Also tried an older version in one of the forum posts after windows updated.  Went back to newest version.

Archer T6E V1

Carrier is Xfiniti

Wifi Router is:

System Hardware

Model:CGM4331COM

Vendor:Technicolor

Hardware Revision:2.0

Serial Number:304930040483110256

 2.4 channel is 6, 5 channel is 44  (I can't change them myself, have to have comcast do that.)

 

WPA2-PSK (AES) security

Mode  802.11 a/n/ac802.11 a/n/ac/ax 

 

 

I see the WiFi, I can enter the security code, it asks if I want an open network, and then it says can't connect to network.  All other devices connect to the router fine.

 

 

 

  1      
  1      
#1
Options
1 Reply
Re:T6E V1 Not Able To Connect after selecting public or private network
2021-09-07 07:51:52

@MB_Campbell I am seeing this started happening to me this evening.  Archer ac 1900 t9e card was working fine.  Now does not :( 

 

  0  
  0  
#2
Options