CLI VR2600
Hello,
where can I found manpage and more for CLI Archer VR2600.
First I will close all open ports (ssh... ) to internet. It was surprise that i can connect to Webinterface over Internet.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
To be able to access WebGUI of the device through Internet you need to have remote management enabled:
The other way device to be managed from outside your network is through CWMP, configured by your ISP:
To open ports for accessing services through Interenet, you should have configured virtual servers :
or DMZ:
And finally if you have UPnP on the device enabled and there are any services in the table:
If you haven't enabled these you shouldn't have access to the WebGUI or services from outside your network.
- Copy Link
- Report Inappropriate Content
I do'nt want to manage over Internet and remote managed ... is disabled.
When I scan man IP (Internet side) port 21 ftp
22 ssh
23 telnet
53 domain
80 http
1900 upnp
8200 trivnet
20005 btx is open
I want to close all these port, unless 80
thx
- Copy Link
- Report Inappropriate Content
I search the manual for cli (telnet) and hope I can solve some problems.
- Copy Link
- Report Inappropriate Content
Is your WAN IP address public or private ?
If you haven't configured DMZ or Virtual Servers there shouldn't be any open ports on your device.
Can you test while UPnP is disabled to scan again for open ports ?
I've never seen any CLI user guide for this device, but you can type:
'help'
'?'
commands to see if there's any intergrated help menu.
An old thread regarding telnet CLI, which maybe helpful.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 781
Replies: 4
Voters 0
No one has voted for it yet.