[Solution] Wi-Fi speed drops down after updating Deco M4 to the latest 1.5.0 firmware
This Article Applies to:
Deco M4 V1/V2, firmware version 1.5.0
Issue Description/Phenomenon:
Some customers may report that when the internet connection type is PPPoE together with an internet VLAN ID, after updating to the latest firmware 1.5.0 on Deco M4, the Wi-Fi speed slows down and the wireless connection becomes unstable.
Solution:
If you experience the same issue, please install the following beta firmware on your Deco M4, then confirm if the speed and connectivity again.
Deco M4 1.5.0 Build 20210804 Rel. 77124
Note: This modification will be included in the next official firmware, which will be coming soon.
For any other issues starting just after the 1.5.0 firmware upgrade, the above firmware is also worth a try. If that issue could be fixed, please comment below so that we could update this post. While if it is not working, please start a new thread with detailed information about your new issue.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Since last update the speed dropped down to 50% of used to be. I reseted, set up a new net and fault goes on. The current version is 1.5.2. Any tip on what I could try?
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for the feedback.
Could you please help me check the following details as well:
1. May I know who is your internet service provider? And what is the internet connection type, like dynamic IP or PPPoE?
2. How much bandwidth you have subscribed from the provider and how much you could get now?
3. May I know how Deco units are linked together?
- Copy Link
- Report Inappropriate Content
Hi,
I live in Italy and I own n. 4 Deco M4.
My internet provider guarantees me a 1Gb bandwidth and, if I connect directly to the modem (both in WiFi and in Eth), I can reach speeds of 940 Mbs; while, if I connect to my Deco M4 in WiFi (I use them in AP mode) I do not exceed 90 mbs.
Firmware Version: 1.5.2 Build 20210916 Rel. 56193
Please, how can I solve?
Thank you very much!
- Copy Link
- Report Inappropriate Content
Hi, Thank you for reaching out to the forum.
I think your case is no longer related to the original post and could you please start a new post with the following information:
I think your current issue might be related to the WAN link speed of Deco.
Are you able to check the link speed of the port which is connected to the main Deco M4 from the ISP router, or do you have any wired laptop which could be connected to the main M4 and test the Ethernet speed of Deco?
Please also refer to the private message for more information.
Thank you very much.
- Copy Link
- Report Inappropriate Content
I have a PC directly connected on M4 lan port and it works perfectly.
If I connect all my devices on M4 WiFi, they don't work: the speed is slow.
- Copy Link
- Report Inappropriate Content
Hello, I am facing the same issues, system was working properly, but suddenly wifi started disconect the sattelites and wifi is poor even next to the main device, I have tried updating firmware but the problem remains the same.
- Copy Link
- Report Inappropriate Content
@TP-Link does this support M4R v3?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 14495
Replies: 47
Voters 2
