HI,

I'm using my AX50 AX3000 recently acquired with the 5Ghz interface set with 802.11ax only for vr purpose but, when I assign the 120 DFS

channel it switch it automatically into on a lower DFS channel some minute after (sometimes no DFS channel at all). Due to that i cannot use the full bandwidth of this interface.

I'm getting some image shuttering due to the WIFI link bandwidth stuck at approximately 1200 mbps ceiling. (a bit inconvenient but still playable)

There is sure an known issue with the WIFI due to the last update of my headset but I would like to be sure that my router is not anymore the part of my issue

by using the full usable connectivity of 802.11ax .

I'm about 4 to 5 meter of my router in the same room (home basement), the ax50 is link by Ethernet to my ISP router and my PC is link to the router with an another cable.

my wifi link between the ax and my vr headset fluctuate between 500 to +- 1200 mbps (know firmware issue but right now its about the ceiling).

Here my settings. (I'have done some adjustment to mitigate my vr headset issue)