E4 always appear red light
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After few months used. Suddenly fail connection and always appear red light only.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Check on the app and see if the device is still reading as connected, my guess it will say it isn't. If so reset the device and re-adopt it back into the Deco.
Hopefully a reset should fix it for you, the RED light is simply indicating it cant communicate with the other Deco nodes
- Copy Link
- Report Inappropriate Content
been trying also yesterday. Pin in the reset button but no response from deco.
- Copy Link
- Report Inappropriate Content
Hi, Did you mean when holding the reset, the red LED is always here, not changing from yellow-then blinking blue?
If yes, have you tried the firmware recovery here:https://www.tp-link.com/support/faq/2958/?
By the way, is there any firmware upgrade, power outage, or anything unusual?
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1042
Replies: 3
Voters 0
No one has voted for it yet.