[New Firmware] 1.5.1 for Deco E4/ Deco W2400
Hello, thanks for your reply.
The following steps taken:
2.4G was disabled (althou, two month ago, it was not disabled, but still shown 90MBps)
Network was disconnected and connected again (as below).
Then speed test was conducted again:
As below.
As you can see, the result is the same.
To do clear experiment below is test, which was conducted directly on AP Asus router:
Answering your questions:
1. Only one main tower of E4 is connected to the AP router via UTP network cable.
Other 3 towers/bicons are not linked to AP by any means besides via main unit of E4.
2. There are total of 10 devices were connected to Deco system at the time of measure.
As you can see below, the trafic on them is neglectable.
However some of the devices connected to deco slave tower not over WiFi , but by ethernet cable.
4. There, answering your next question, is the speed property of the connection, as below:
5. I conducted speed test on the cable connection as well:
The result is similar to the WiFi test.
The connection between towers are optimized, as below:
In conclusion to add that all those screenshot were taken at approximately same time, as it derrives from the reflected figures in them.
Please, see if you can assist. (In my hamble opinion, it's the firmware bug, as it happened just after update, but I could mistake)
TP-Link wrote
The new firmware 1.5.1 has been released for Deco E4 and Deco W2400 recently, please refer to the following information to get more details.
Modifications and Bug Fixes:
1. Fixed the problem that Zoom applications are banned by the Pay-to-Surf category under Parental Control.
2. Optimized the IPTV/VLAN feature.
3. Added Network Optimization feature.
4. Added the switch of "ignore Ping from WAN".
5. Added the "Service name" and "Access name" option when the Internet Connection Type is PPPoE. (For Deco E4 only!)
6. Added the feature of changing owner account.
7. Improved system security and reliability.
Notes:
1. This firmware can't be downgraded to the previous 1.4.x version!
2. Please update your Deco APP to the latest version for the new features.
3. If there are other Deco models in your Deco network, you may miss some new features till other models release updates in the near future.
4. The firmware upgrade is applied in sequence to the correct devices during the release process so not all users would get the new firmware notification in the first place.
