C54 keeps dropping connection on AP mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello I have C54 on AP mode wan wired to my main router AX50 and it keeps dropping connection a lot, works after restart but then continues to drop, I updated to the last firmware and the issues is still there, tried to put it on device priority on my AX50 but still same problem..
Please help and thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Did you configure the C54 by referring to the below instructions? Check again the C54 is connected to the AX50 via LAN-LAN:
https://www.tp-link.com/support/faq/1199/
BTW, is the AX50 internet stable if you connect a PC directly to its LAN port? Ensure this is stable first, then change with a different cat5e or cat6 cable between the AX50 and the C54 if it is necessary.
- Copy Link
- Report Inappropriate Content
@Kevin_Z AX50 internet is indeed stable, and yes im using LAN-LAN but i dodnt do the 3rd step
- Copy Link
- Report Inappropriate Content
I have the same setup as yours and I've not had any problems with the C54.
modem --> Archer AX50 --> Archer C54 (AP mode)
--> Archer C24 (AP mode)
Try to follow the instructions (including the diagram) on the C54 User Interface when setting it in AP mode, it says there that once you set it to AP mode, you have to connect it from the LAN port on the AX50 to the WAN port on the C54. The only additional step you may want to do is to set it to a specific IP address and disable the DHCP Server function.
If you also want to upgrade the firmware on the C54, check the link below.
I hope this helps.
- Copy Link
- Report Inappropriate Content
Please change the LAN IP address of the C54 to be in the same IP subnet as the AX50, then reboot the whole system and check.
- Copy Link
- Report Inappropriate Content
@CHIBOMAN I did the that, it gotten a little better but still eventually drop :(
- Copy Link
- Report Inappropriate Content
check/change the LAN cable going to the C54 if possible and also just for isolation relocate the C54 power adapter to a different outlet.
you can also set the wireless channel on the C54 to be different from the AX50, for example if the AX50 2.4ghz was on channel 3 ... then have the C54 on channel 9. do the same for the 5ghz frequency channel.
don't use same channel on both wireless routers.... like channels 1-6 on router A and channels 7-11 on router B.
- Copy Link
- Report Inappropriate Content
@CHIBOMAN how can i change the channels?
- Copy Link
- Report Inappropriate Content
@CHIBOMAN nevermind i got it, lets hope it works
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1885
Replies: 8
Voters 0
No one has voted for it yet.