Blurams video doorbell with archer-ax11000

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Blurams video doorbell with archer-ax11000

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Blurams video doorbell with archer-ax11000
Blurams video doorbell with archer-ax11000
2021-05-03 15:16:11
Model: Archer AX11000  
Hardware Version: V1
Firmware Version: 1.1.1 build 20200716 rel,84595

hallo, 

 

 

I have a Blurams video doorbell with a Wireless Protocol:  IEEE 802.11b/g/n 2.4GHz and Protocols: 64/128-bit WEP、WPA/WPA2、WPA-PSK/WPA2-PSK、WPS.

before i instal the archer-ax11000 i got a modem from my ISP and the TL-WPA8631P KIt . my doorbell a 4 meters from the modem got the best wifi 100% it says. 

after i install archer-ax11000  it drops from 100% to 30% and i have the archer-ax11000 on the same spot as the ISP modem.

 

what have I tried:

 

Smart Connection ON

Smart Connection OFF 

archer-ax11000 together with TL-WPA8631P KIt without OneMesh but the connection was a little better but with a lot of connection dorps 

 

 

does anyone have a solution to this problem

 

 


 

 

 

 

  0      
  0      
#1
Options
1 Reply
Re:Blurams video doorbell with archer-ax11000
2021-05-07 07:22:13

@stefan0028 

 

May I know the model number of the old ISP modem?


Please check and ensure the Transmit Power on the AX11000 2.4G is set to be High, then you may try to modify the wireless channel and channel width settings on it to monitor again. As for the 2.4G, you can change the channel to 1/6/11, channel width to 40MHz, or you may run a Wi-Fi analyzer to review the channel, then choose one with better signal.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options