TP- LINK AC1350 (ARCHER C58)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP- LINK AC1350 (ARCHER C58)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP- LINK AC1350 (ARCHER C58)
TP- LINK AC1350 (ARCHER C58)
2021-04-18 20:55:15 - last edited 2021-04-19 02:23:47

Greetings everyone,

 

I would like to ask if it's possible to do what I describe below: 

 

I have a modem/router AC1200 (Archer VR400) and a router AC1350 (Archer C58). I would like to connect wirelessly the 2 devices in order the Archer C58 can connect on the internet using no cables etc. Is that possible? 

 

I tried to connect Archer C58 using WDS Settings either on the same device and on Archer VR400 but nothing happened. Tried to setup a DHCP but still nothing. The only way to connect Archer C58 on internet is only through cable, connected on Archer VR400.

 

If you have any workaround would appreciated it.

  0      
  0      
#1
Options
1 Reply
Re:TP- LINK AC1350 (ARCHER C58)
2021-04-20 15:28:00 - last edited 2021-04-21 03:01:48

@Maegllin 

 

Configuring WDS has to be done only on one of the devices - in your case C58, if you want to extend your wireless network created by VR400.

In your user guide (HW v2 and HW v1 are pretty much the same):

https://static.tp-link.com/Archer%20C58_V2_User%20Guide.pdf

https://static.tp-link.com/res/down/doc/Archer_C58(EU)_V1_UG.pdf

in the FAQ section, on the very end there's a "Q4 - How  do I use the WDS Bridging function to extend  my wireless network ?"

Follow these steps to configure WDS on C58.

You can also use this FAQ.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options