Wifi router/extender is connecting only to some devices

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wifi router/extender is connecting only to some devices

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wifi router/extender is connecting only to some devices
Wifi router/extender is connecting only to some devices
2021-03-23 22:47:01 - last edited 2021-03-24 05:29:46
Model: TL-WR941HP  
Hardware Version:
Firmware Version:

Hi, i connected this model to my main line as a modem, it connects only to my laptop, my phone and my mother's but not to my brothers pc, my father's pc nor my father's phone.

On the PCs it says connected with no internet, and on the phones it doesn't even connect

  0      
  0      
#1
Options
1 Reply
Re:Wifi router/extender is connecting only to some devices
2021-03-26 11:16:14

@Fran910 

 

This WR941HP is a router, it cannot be working as the modem. Please verify again if it connects to the internet correctly, ensure there is a WAN IP address. Who is your ISP, BTW? You can try to clone the main PC's MAC address to the WR941HP by following this guide:

https://www.tp-link.com/support/faq/68/

 

Meanwhile, ensure there is no special settings on the WR941HP, such as black list on the Access Control settings page:

https://www.tp-link.com/support/faq/1914/

 

It is suggested to reset the router to factory defaults by pressing the RESET button on the back panel, then reconfigure it from scratch to check if it will be working properly on all the devices. You can also follow this guide to confirm the settings on it:

https://www.tp-link.com/support/faq/1556/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options