Deco not connecting to the strongest signal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco not connecting to the strongest signal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco not connecting to the strongest signal
Deco not connecting to the strongest signal
2021-03-07 14:19:40
Model: Deco M9 Plus  
Hardware Version:
Firmware Version: 1.4.3

I am using three m9 deco, working fine. Only the one on the top floor is recently switching to the deco on the ground floor instead of the deco on the first floor. The signal on the first floor however is much stronger for the top floor. Any way you can influence connecting the top floor always to the first floor?

  1      
  1      
#1
Options
2 Reply
Re:Deco not connecting to the strongest signal
2021-03-08 03:15:23
  0  
  0  
#2
Options
Re:Deco not connecting to the strongest signal
2022-01-26 16:36:01

@TP-Link 

M4 and M9 Plus don't have such update and they are practically unusable... Deco seems as super dump device when selecting "Strongest signal". And gues what - usually the Deco is wrong. Half of my Decos are flashing red, because they are trying to connect to the master source.

Please, provide correct support for your products and allow changing of the signal source!

Frustrated Deco (X90, M9 Plus, M4R, E4) & Tapo (C200, C210) owner looking for solutions to use the investment in them. Expensive Plastic...
  0  
  0  
#3
Options