2nd Access point - confusion over client count
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Until today I had only a single EAP110 but wanted to add a model that supported MU-MIMO.
So I bought an EAP 225 which I connected up and the Omado controller software (on Windows 10) found the EAP225 and I adopted it in.
Because I wanted to keep this seperate from the working environment I created a new WLAN which is only assigned to the new AP (EAP225). From my Android phone, I can connect to the WiFi and all seems to work fine (I know it's not using mobile data on the phone because I have switched that off.
But I can find no record in the console of the client existing (it doesn't show up on the default WLAN for the original EAP110)
Everything attached to the original WLAN funtions correctly and shows up in the console.
Firmware for both EAPs is the latest version.
What am I missing?
Thanks in advance
BB
Hey
I think I know what your issue is.. Its a firmware incompatability
You are running Controller v3 The Firmware on your EAP110 is fine for that version of SDN... however the EAP225 v3 on Firmware 5.0.0 requires Controller version 4.1.5 or higher..
You have 2 options..
1. Downgrade the firmware on the EAP225 v3 to EAP225(EU)_V3_2.7.0 Build 20200113 and this will allow it to work OK with the v3 Controller
or
2. Upgrade the Controller to V4.2.11 (newest at moment) and also upgrade the EAP110 v4 to EAP110(EU)_V4_5.0.0 Build 20200914 and this will enable its support for V4 controller.
Personally... I would pick the v4 upgrade (option 2) as the v3 controller is starting to become end of life now.
Hope that helps!