Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51
Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51
2021-02-22 15:35:14 - last edited 2021-03-11 10:20:54
Model: Deco M9 Plus  
Hardware Version: V2
Firmware Version:

My M9 plus have always had problem with satellite going down, usually before firmware 1.5 it was only one at the time that went red blinking and then it came up automatically again after 2-3 minutes. With firmware 1.5 and up both is going down alot can be between 15 minutes or 1 hours, 2 hours, but they are usually dead for 30 min or more, can be green can be blinking red (mostly green).

 

Main M9 Plus is stable., I have rotated AP around and I dont think its AP, or its all of them that is bad.

 

But how can I downgrade firmware, 1.42 was alot better, still going down but its was about 3-5/day.

 

 

/Anders

  0      
  0      
#1
Options
1 Accepted Solution
Re:Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51-Solution
2021-03-11 10:20:43 - last edited 2021-03-11 10:20:54

@Andi411 Ending this, so frustrated, searching for another mesh to exchange this one.

Recommended Solution
  0  
  0  
#5
Options
3 Reply
Re:Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51
2021-02-23 06:29:12

@Andi411 

Hi

Nice to see you again.

Have you tried to swap a different Deco as the main Deco to see whether that helped or not.

https://www.tp-link.com/en/support/faq/2400/

At the same time, I would like to forward your case to the senior engineers and please have a check of your email box later.

Thanks.

  0  
  0  
#3
Options
Re:Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51
2021-02-23 06:44:20

@TP-Link 

Yes I have every deco have been main. First node is always ok, it's the satellite that goes down, all of them. Have only one satellite now and that is down again and will not connect automatically again.

 

firmware before 1.5 was better only happens 3-5 times a day and only one and it connected automatically in 2-3 minutes.

 

 

  0  
  0  
#4
Options
Re:Deco M9 Plus, satellite drops alot after firmware upgrade 1.50, also 1.51-Solution
2021-03-11 10:20:43 - last edited 2021-03-11 10:20:54

@Andi411 Ending this, so frustrated, searching for another mesh to exchange this one.

Recommended Solution
  0  
  0  
#5
Options