TP-Link AX10 Problem with IPV6
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have the Archer AX10(US)_V1.2_201230 The latest firmware. I am ONLY using IPV4 internet and do not really use IPV6. The router interface show that the router itself has an IPV6 address
I have a test enviroment with VOIP phone Yealink and server windows 2012. The windows server run Dhcp the router TPlink Ax10 have SIP APG off Upnp off only 1 port forwarding to server at 443 for VPN via SSTP.
Port scan from a IPv4 internet was fine only 1 port open 443 when I run port scan.
However when I run the port scan from a IPV6 device, sudden the port scan showing port 21 80 443 554 1723 all open on my IP. The router has remote management off no FTP running anywhere I can see VPN on router also off. Upnp off so nothing should be able to punch hole and open port. I am at a lost.
This is something weird with the router not blocking it own IPV6 I think.
Have you disabled IPv6 form the router menu ? Try that if you haven't and see if any difference:
