Deco M4 select signal source
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I got 3 deco M4 device, 1 as main (AP mode) and slave 1 and slave 2.
Main deco and slave 1 are located at ground floor while slave 2 is located at floor 1.
Main deco is located under the stair so the signal strength is weak a bit, but the speedtest done when client device connect to slave 1 still good.
Problem here is slave 2 connect to main deco instead of slave 1 when slave 1 have greater signal strength compare to main deco.
I saw another post Deco M5 source signal selectable? got release beta firmware for M5 model.
May i know when will m4 beta firmware release? or does it have any other temporary solution?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi All，
Currently, We are working on the firmware that supports selecting signal sources manually.
Please keep an eye on Deco APP and once we release the new firmware, you will get a notification.
For more details, please refer to this link:
[Deco] Manual Signal Source Selection
Thank you very much.
- Copy Link
- Report Inappropriate Content
@NoGameNoFun i am also wondering this, has been driving me crazy...
- Copy Link
- Report Inappropriate Content
@NoGameNoFun Same issue over here. I also saw there is a beta version for M5 but nothing for M4.
I also saw you can turn the deco into an AP, but this applies to the hole network, not for a specific Node, which doesn't make sense at all...
https://www.tp-link.com/us/support/faq/1842/
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Thank you for starting this topic for Deco M4, I am also interested to see how this could be solved.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Have you tried to contact Deco support through the Deco app?
if you do this it will register a support case that is followed up by a support team.
I am currently running beta firmware that they shared and it looks like it is doing the job!
- Copy Link
- Report Inappropriate Content
No, I Just check this topic, where is the beta version for m4? could you please share download link?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 9
Views: 20159
Replies: 80
Voters 8
