Deco M4 select signal source
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I got 3 deco M4 device, 1 as main (AP mode) and slave 1 and slave 2.
Main deco and slave 1 are located at ground floor while slave 2 is located at floor 1.
Main deco is located under the stair so the signal strength is weak a bit, but the speedtest done when client device connect to slave 1 still good.
Problem here is slave 2 connect to main deco instead of slave 1 when slave 1 have greater signal strength compare to main deco.
I saw another post Deco M5 source signal selectable? got release beta firmware for M5 model.
May i know when will m4 beta firmware release? or does it have any other temporary solution?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
yes, and please have a check of your email box later;
Thank you very much.
And if anyone had the same signal source selection issue on the Deco M4, Please also leave me a private message;
We also have the firmware for Deco M5, Deco M9 plus as well as Deco X60, and if needed, please feel free to let me know;
Thanks.
- Copy Link
- Report Inappropriate Content
@TP-Link Please can you send me the link for the beta firmware. Thanks
- Copy Link
- Report Inappropriate Content
ok I need this also. This is killing my 200mb broadband into my back office which I specifically bought the decos for to provide a strong reliable signal too and all the 3rd slave can do is pick up the weakest main deco in the living room providing a poor unreliable signal.
how do I get this beta firmware?
thanks
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Samora I've PM'd you
- Copy Link
- Report Inappropriate Content
Hi, thanks for your help.
Are you sure this is the beta firmware that allows to select signal source ?
Tried do flash the firmware but after all the process the firmware stayed the same.
I did the upgrade attempt connected via ethernet...
- Copy Link
- Report Inappropriate Content
@TP-Link Can you send the Deco M4 firmware uptade to me please? Thanks
- Copy Link
- Report Inappropriate Content
@TP-Link have two m4's and one e4.
1) M 4 is the main one connected to the ethernet. 2) now the problem is that i want one of the m4's to get signal from my e4 as the other m4 is further from the main M4 and closer to E4
- Copy Link
- Report Inappropriate Content
@Samora no it doesn't allow you to select the source but it stops the 3rd deco connecting to the first :)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 9
Views: 20192
Replies: 80
Voters 8
