Silly number of errors in M9

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Silly number of errors in M9

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Silly number of errors in M9
Silly number of errors in M9
2021-02-18 02:00:58 - last edited 2021-02-18 02:02:50
Model: Deco M9 Plus  
Hardware Version:
Firmware Version: 1.4.3

I just set up a Deco m9 and when I have a look at the system logs there are hundreds and hundreds of errors per day.

 

I have 3 m9s. The 2 satellites are set up to backhaul over Cat5E. I have good speed and no issues with the network but am curious about all the errors.

 

Some of the errors I get are:

 

Wed Feb 17 18:37:05 2021 user.err csrMeshGw[5755]: MSGQ :: CsrMeshGetMsgFromTxQueue curTxIndex : 0, tag count : 2, length : 30

Wed Feb 17 18:37:05 2021 user.err csrMeshGw[5755]: CsrMeshMsgQRead: qId=0 errno=42, No message of desired type!!!!

Wed Feb 17 18:37:19 2021 daemon.err miniupnpd[24044]: sendto(udp_notify=12, [::1]): Network is unreachable

 Wed Feb 17 18:37:25 2021 user.err csrMeshGw[5755]: CsrMeshMuxDemuxFindModelRes : Event : 0xef01, Response Event : 0xffff

Wed Feb 17 18:37:43 2021 daemon.err client_mgmt: client(DE-26-FC-7C-E0-E0) not found in arp table disconnect_counter=0

Wed Feb 17 18:52:06 2021 user.warn IMPROXY: WARNING[mcast_recv_igmp@753]: Don't exist this Downstream VIF

Wed Feb 17 18:53:09 2021 user.notice IMPROXY: INFO[mcast_to_ex_hander@170]: Group 239.255.255.250 Group Compatibility Modeis lesser than IGMPV3

Wed Feb 17 18:53:09 2021 user.notice IMPROXY: INFO[imp_verify_multicast_addr@245]: Group address 224.0.0.251 is Local Network Control Block

 

Whay am I getting so many errors? Are they an Issue? What can I do about it (or should I leave it)?

  0      
  0      
#1
Options
1 Reply
Re:Silly number of errors in M9
2021-02-18 02:48:42

@99Driver 

Hi

There is no obvious issue based on the system logs.

Some of the logs would appear when it disconnected from the Deco units or switched from one to another.

You could monitor the performance of the clients and feel free to update here with new findings.

Thank you very much.

 

  0  
  0  
#2
Options