MAC address filtering issue on Archer AX73.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello.
I bought new great wifi router - Archer AX73. But I have an issue with MAC address filtering (white list).
I did a simple test:
- enable MAC address filtering with white list option and add few devices to white list (devices which use wifi and cable),
- restart router, and after restart the only cable devices can connect to my network, all wifi devices are blocked.
The "solution" is: disable MAC address filtering and restart router again, but it is not acceptable solution.
Also adding new MAC address to the existed white list gives no effect. After add new device, restart is required with disabled MAC filtering, and then enable it again.
Kindly want to ask you - do you have similar problems with Archer AX73 router? I believe it is firmware issue, but not sure...
Regards,
Maciej
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
no, the three-line option can be dropped.
I made several reboots - periodically, a double and even triple set of them also appears ...
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Good news :)
I've got the beta firmware also, but I will install it after weekend.
Any changes in system log after reboot?
- Copy Link
- Report Inappropriate Content
I found a small glitch in the Log of beta firmware. After turning off miniDLNA, the system log shows the following lines:
2021-02-26 16:52:26 Обмен данными по USB УВЕДОМЛЕНИЕ [9607] MiniDLNA start
2021-02-26 16:52:26 Обмен данными по USB УВЕДОМЛЕНИЕ [9607] MiniDLNA stop
As I understand it, after stop, the service starts again.
But, in the web interface, the switch is in the off position
Other devices do not see the DLNA-server on the network.
However, when installing the flash drive, an entry appears in the log:
2021-02-26 17:00:25 LED индикатор ИНФОРМАЦИЯ [1105] Start to run USB3
2021-02-26 16:56:52 LED индикатор ИНФОРМАЦИЯ [1105] Start to run USB3_ON
2021-02-26 16:56:47 LED индикатор ИНФОРМАЦИЯ [1105] Start to run USB3_twinkle
2021-02-26 16:56:47 LED индикатор ИНФОРМАЦИЯ [1105] Start to run USB3_twinkle
It looks like the miniDLNA service is still working, although it is not available from the network.
Maybe i'm wrong
- Copy Link
- Report Inappropriate Content
I noticed a beta glitch.
A couple of days after the last reboot, the power of the radio signal in both bands dropped sharply. Decreased markedly. I rebooted router. At 2.4, it seems to have returned to normal, and at 5 GHz, it seems that it is generally weaker on this firmware than on the previous one. About 8 - 10 dbm less. (channel 36, 160 mhz).
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hm....
Beta:
1.0.1 Build 20200907 rel.76867(4555):
- Copy Link
- Report Inappropriate Content
Firmware 1.0.2 Build 20201112 rel.53967(4555) solved all the problems. So far, I have not identified any failures on it.
- Copy Link
- Report Inappropriate Content
Any other firmware?
I want to install today evening beta firmware, but... Have you got any other one? From where did you download it?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 8159
Replies: 44
Voters 0
No one has voted for it yet.