How can I set one AP to channel 1 and another connected AP to Channel 6 or 11

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2021-02-10 13:52:51 - last edited 2021-02-15 07:35:37

Posts: 36

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2020-12-10

How can I set one AP to channel 1 and another connected AP to Channel 6 or 11

2021-02-10 13:52:51 - last edited 2021-02-15 07:35:37

Model: Archer A20

Hardware Version: V5

Firmware Version:

Hello Sir/Madam,

I have 2 WiFi routers (SSIDs = JUPITER and DLINK) interconnected as shown in the attached diagram (PNG file).

I am interested in dedicating the A7 (SSID=JUPITER) to Channel 1 and the DLINK (SSID=DLINK) to Channel 6 or 11.

But setting the A7 to Operation mode = AP does not allow me to get to a screen where the Channel selection is possible.

The DLINK allows me to select the channel but the A7 in AP mode does not.

Is there a way around this?

Thanking you in advance.

File:

1 Accepted Solution

LV7

2021-02-10 14:11:44 - last edited 2021-02-15 07:35:37

Posts: 6971

Helpful: 5187

Solutions: 1126

Stories: 7

Registered: 2013-10-12

Re:How can I set one AP to channel 1 and another connected AP to Channel 6 or 11-Solution

2021-02-10 14:11:44 - last edited 2021-02-15 07:35:37

Does that help:

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".