Archer A9 Duplex Setting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer A9 Duplex Setting
Hello:
I'm using the Archer A9 as a WAP. It is connected to my modem via Cat6. It is showing 100Mbps negotiation (full duplex). I want to reset it to 1000Mbps. I've tried using the router configuration and going to Advanced System and changing it, but it won't save the changes. Any ideas?
Thanks
Re:Archer A9 Duplex Setting
If your device is in router mode:
If the setting is Auto then change it to 1000 Mbps/full duplex (If it is set to 1000 Mbps then change it to Auto):
.
Then reboot the device and observe the result here :
If the device is in AP mode:
you can just observe the negotiation speed here:
In that case you can only re-plug the cable from both sides (router and modem) and observe if the negotiated speed is correct.
If this was helpful click once on the arrow pointing upward.
If this solves your issue, click once the star to mark it as a "Recommended Solution".