Wifi after power cut in AP mode. Possible bug?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wifi after power cut in AP mode. Possible bug?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wifi after power cut in AP mode. Possible bug?
Wifi after power cut in AP mode. Possible bug?
2021-02-06 22:28:15
Model: Archer C9  
Hardware Version: V5
Firmware Version: firmware 1.2.4 Build 20190403 rel. 63869

I have an Archer c9 v5 firmware 1.2.4 Build 20190403 rel. 63869 (5553) in access point mode.

 

When I turn it off for some reason (if I am not going to be there for a few days for example) then when I turn it on, the wifi does not work (the ssid is not listed in the area). I have to go into admin and make some change to the wifi settings to get it to turn on (example change signal strength) and then it works properly. I think it is a simple mistake to repeat to see if it is a general software problem as it always happens

 

Thanks.

 

Notice:  I used a translator and had written this same in the Spanish forum without success.

  0      
  0      
#1
Options