Hello all

I must be missing something with setting up my VR600...

I use it as an access point connected to my main modem (which is also a router, non TP-Link) LAN to LAN.

It's the third TP-LINK device connected to the same main router (each one is connected as an access point with different wireless network name).

The other 2 devices are older ones (TL-WR841ND).

When the other 2 devices are connected, the allow me to connect both wire/wireless, and most important, the wireless option on the main router works also.

However, when I do the same steps on my VR600 (disable DHCP, set a new wireless network name), it won't work wirelessly, only wired.

Only if I switch off the wireless option on the main router, it will work on the VR600.

So to make a long story short.....:

Why do the VR600 behave differently from the older products?

Is there any way to configure it so both the main router and the VR600 works also wirelessly?

Thanks a lot

Nitzan Gertz