Any updates on OneMesh on AX10?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Any updates on OneMesh on AX10?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi everyone.
Any updates on OneMesh? It was suggested earlier it might arrive near the end of 2020 (I remember I read somewhere in the forums).
Thanks in advance!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
There might be delay on the local website, you can download the latest firmware from the global website if your AX10 is an EU version, please verify this first by checking the device label. You can download the firmware for the US version from this site:
https://www.tp-link.com/us/support/download/archer-ax10/v1/#Firmware
- Copy Link
- Report Inappropriate Content
@Kevin_Z I finally managed to get the latest update for my Archer AX10 that is supposed to support OneMesh but my extender (RE190) still states that the host doesn't support OneMesh... I tried to factory reset it, reboot it, reconfigure it according to the link you shared but still no luck... Any idea why?
For info:
- my AX10 is running firmware 1.2.0 20210420 in Access Point mode
- my RE190 is running firmware 1.0.3 20201030
help would be greatly appreciated as the OneMesh functionality is the reason I dropped my previous wifi router and bought the AX10...
thanks in advance!
- Copy Link
- Report Inappropriate Content
Hello, thanks for asking.
The Onemesh router can only build up the Onemesh network with the range extender when it is working in Router mode. You may check the QAs in the below article:
https://www.tp-link.com/support/faq/2690/ (Q8/A8)
You can know more about the inquiries here:
https://www.tp-link.com/onemesh/
You need to change the AX10 into Router mode, then check if you can add the RE190 to the Onemesh network.
- Copy Link
- Report Inappropriate Content
@Kevin_Z I update to the new firmware yesterday and rebooted on my AX10 but when I try to activate onemesh on the extender connected to the AX10 it says the router doesn't support OneMesh. Any ideas ?
- Copy Link
- Report Inappropriate Content
@Kevin_Z Hi, I've update my router to the latest formware but I don't see the option to activate OneMesh
- Copy Link
- Report Inappropriate Content
Is it AX10 V1.20 or V1? You can check this thread we updated, download and install the correct firmware on your router:
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 5704
Replies: 16
Voters 0
No one has voted for it yet.