M9 Plus will not connect to Xfinity XBT7 Gateway in Bridge Mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Have done a lot of searching on this and cannot find a fix after rebooting everything multiple times. I put the XBT7 in Bridge mode and connected my Main Deco to the XBT7 via Cat5 to XBT7 port 1. The Deco stays red and will not connect.
From what I have read I am supposed to be able to connect just fine to the XFI Gateway in bridge mode? If I disable bridge mode on the XFI gateway and just turn off the WiFi the Deco connects just fine. I am confused why Bridge mode will not work.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I was able to clone the MAC address into the Deco which allowed it to finally connect. By doing so my internet speed is awful dropping to 20 Mbps.
- Copy Link
- Report Inappropriate Content
Anyone had the same issue and fixed it?
- Copy Link
- Report Inappropriate Content
Hi,
What is the required internet connection type of your internet service provider since from the detailed you have provided, it is not dynamic IP, more like PPPoE with username and password;
And when the Xfinity XBT7 Gateway in Bridge Mode, if you connect a computer to the modem, are you able to get internet service?
Thanks a lot and wait for your reply.
- Copy Link
- Report Inappropriate Content
@TP-Link It is user name/password to connect.
When in bridge mode the cable modem connected to the PC does provide internet access to the PC just fine.
- Copy Link
- Report Inappropriate Content
I was able to clone the MAC address into the Deco which allowed it to finally connect. By doing so my internet speed is awful dropping to 20 Mbps.
- Copy Link
- Report Inappropriate Content
Issue resolved.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1094
Replies: 5
Voters 0
No one has voted for it yet.