Archer C9 firmware upgrade shows TP-LINK BETA

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C9 firmware upgrade shows TP-LINK BETA

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C9 firmware upgrade shows TP-LINK BETA
Archer C9 firmware upgrade shows TP-LINK BETA
2020-12-25 22:51:01
Model: Archer C9  
Hardware Version: V1
Firmware Version: 3.17.1 Build 20201118 Rel. 42895

I updated my router with the latest firmware released from TP-Link. I downloaded the right firmware from 

https://www.tp-link.com/us/support/download/archer-c9/v1/#Firmware

 

After the firmware upgrade.

1. The router reset to factory reset. This was not the case for the previous router firmware upgrade that i did couple of times in previous years.

2. The management page at 192.168.0.1 shows TP-LINK beta watermark across all the pages. 

 

Is this fine? Should i revert back the firmware?

 

  0      
  0      
#1
Options
1 Reply
Re:Archer C9 firmware upgrade shows TP-LINK BETA
2020-12-28 08:45:45

@samjag 

 

Hi, thanks for asking. This version seems to be a beta firmware, while it should be OK to install it on your router, you may just keep it and reconfigure the router to connect to the internet.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options