Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Deco M4 Ac1200 Disconnection Problems

< Deco

Deco M4 Ac1200 Disconnection Problems

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M4 Ac1200 Disconnection Problems

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

GeoffRichards

2020-12-24 11:21:58

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-24

Deco M4 Ac1200 Disconnection Problems

2020-12-24 11:21:58

Model: Deco M4

Hardware Version:

Firmware Version: 2.3.2

Hello all,

TLDR: Satellites disconnect from the router. LAN doesn't work.

I've set up my M4 as a router and can use the WiFi and LAN port without any problems. However, whenever I set up the satellite M4's they disconnect (usually) after a few minutes. When they stay connected for a little longer, the LAN doesn't work - it simply says "unidentified network, no internet"... Then it disconnects.

The WiFi signal is good between the M4's, they just randomly disconnect.

Any help would be appreciated.

2 Reply

TP-Link

2020-12-25 09:18:03

Posts: 6831

Helpful: 3028

Solutions: 536

Stories: 28

Registered: 2018-07-23

Re:Deco M4 Ac1200 Disconnection Problems

2020-12-25 09:18:03

@GeoffRichards

Good day,

Thank you very much for your time and patience.

Could you please help me check the following information:

1. Would the satellite Decos turn red when they are disconnected from the main Deco?

2. What is the status of the satellite Deco on the APP When it lost the connection？

3. Would change a different Deco as the main Deco make any difference?

Thanks a lot and wait for your reply.

Deco Monthly Recap- Check What's Currently Going on With Deco KidShield Test Recruitment, Share Your Ideas With us! Wi-Fi Schedule Ideas Wanted!

PRABHURAJAN

LV1

2021-01-14 14:06:24

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-01-14

Re:Deco M4 Ac1200 Disconnection Problems

2021-01-14 14:06:24

@TP-Link

Recently I had purchased a Deco M4 and while setup, the firmware was upgraded to 1.4.3 Build 20200918. I have an issue with the satellite unit. After the initial setup, when I shifted the Deco to the nearby room, the wifi link disconnects and there is a red led pulse. Once I bring it near the main deco unit, it connects. I had done factory reset/swapping the decos uninstall and reinstalling Deco app. Please help me I am frustrated with the setup. I am on a 100 Mbps connection.

Deco M4 Ac1200 Disconnection Problems

Deco M4 Ac1200 Disconnection Problems

Information

Voters 0

Tags