Home

Forums

Stories

Knowledge Base

Home Network Community > DSL Modem Routers > How to turn on NAT loopback?

< DSL Modem Routers

How to turn on NAT loopback?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to turn on NAT loopback?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to turn on NAT loopback?

2020-12-21 12:59:36

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-21

How to turn on NAT loopback?

2020-12-21 12:59:36

Model: TD-W9960

Hardware Version: V1

Firmware Version: 1.6.0 0.8.0 v007c.0 Build 190509 Rel.34459n

Hi there,

how can I enable NAT loopback?

THX

0

0

#1

1 Reply

2020-12-23 03:33:14

Posts: 21782

Helpful: 5154

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:How to turn on NAT loopback?

2020-12-23 03:33:14

Hi, as far as I know, this TD-W9960 supports NAT loopback by default, there is no need to enable it.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

0

0

#2