Secondary Deco's e4r disconnect after power outage - solid red light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Secondary Deco's e4r disconnect after power outage - solid red light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Secondary Deco's e4r disconnect after power outage - solid red light
Secondary Deco's e4r disconnect after power outage - solid red light
2020-12-11 15:55:04
Model: Deco E4  
Hardware Version: V1
Firmware Version: 1.4.3 Build 20200918 Rel. 44982

Hi, after a power outage all the secondaries decos goes to red light solid.

 

I need to reset and do a new add to the main deco.

 

The topology is quite simple. 

 

Principal Deco on router mode, to a direct cable from the ISP with static IP

Secondaries decos (I have 2 of them) connected wireless to the main deco

 

Regards

  0      
  0      
#1
Options
2 Reply
Re:Secondary Deco's e4r disconnect after power outage - solid red light
2020-12-11 16:03:01

 

 

Here is the topology. With the kitchen_1 deco conectect with cable to the ISP with static IP

  0  
  0  
#2
Options
Re:Secondary Deco's e4r disconnect after power outage - solid red light
2020-12-14 05:46:43

@fsandmann 

Good day,

Thank you very much for your patience.

For your case, could you please help me check the following information:

1.Are you able to constantly reproduce the same issue?

2.After the LED went solid red, would rebooting the Deco, power on/off recover the connection?

3.Are you able to test connecting one satellite Deco via Ethernet cable to the main on to see if that helped?

4.By the way, who is your internet service provider? Is there any chance to use dynamic IP as the internet connection type, instead of static IP?

 

Thanks a lot for your understanding and support.

 

 

  0  
  0  
#3
Options