Home Network Setup with DSL Modem and Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Home Network Setup with DSL Modem and Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Home Network Setup with DSL Modem and Router
Home Network Setup with DSL Modem and Router
2020-12-09 08:28:12

Hi,

I have the following Network problem. I have a DSL connection from German Telekom. I use a TPLink VR600v as a modem. After this modem I connected a TPLink VR2600v. Over the VR2600v I connect my mobiles, laptops... and my IP telephone (DECT). All my network should work under the same IP adress range. This is a picture of my setup:

 

  • I handled everything to establish the VR600v. VOIP is also established on the VR600v and is working.
  • DHCP is set "On"

 

  • The VR2600v is currently in Bridge mode connected via LAN (Connection is set to WLAN-Router. My problem is the VOIP installation on the VR2600v. I have no telephone access to the provider
  • DHCP is set "Off"

 

Can somebody advice me how to set up the VR2600v?

  • Which Mode should it run?
  • LAN Cable should be connected to LAN or WAN?
  • DHCP set ON or Off?
  • Are there any settings for Port Forwarding?
  • Are there any setting for Virtual Server?

 

Thanks for the help.

 

  

  0      
  0      
#1
Options
1 Reply
Re:Home Network Setup with DSL Modem and Router
2020-12-23 06:32:04

@Lallkopf 

 

Hi, try to refer to the below instructions to configure the VR2600v into an Access Point, then confirm if the VOIP works:

https://www.tp-link.com/support/faq/2655/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options