ICMP filtering on Deco M4 V2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ICMP is being filtered by the router. I have created firewall rules on my PC to allow ICMP so it must be the router. There is no option in the router settings to disable this. Please add an option to toggle ICMP filtering as it is quite necessary in IPv6 networking.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I fully support this request. I think I saw however a reference that this was coming in versiion 1.5.0
I am trying to monitor my connection using a Broadband Quality Monitor which I cannot do without allow this
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for your feedback.
Currently, Deco M4 did not support this feature.
All your request would be recorded for the further evaluation.
If anyone had the same request, please feel free to update here.
Thanks a lot for your understanding and support.
- Copy Link
- Report Inappropriate Content
@Timothy123 I would also like this feature: it's needed to measure packet loss and diagnose connection problems at our service providers.
- Copy Link
- Report Inappropriate Content
@Timothy123 need this also
- Copy Link
- Report Inappropriate Content
@Timothy123 Mine is working fine following the update to firmware 1.5.0
- Copy Link
- Report Inappropriate Content
@JES Glad to hear this is working for you, can I ask where you found the option to turn it on/off though?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1307
Replies: 7
Voters 0
No one has voted for it yet.