Red Led and no internet connection detected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Red Led and no internet connection detected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

BloNET

2020-12-01 01:04:22

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-01

Red Led and no internet connection detected

2020-12-01 01:04:22

Model: Archer AX6000

Hardware Version: V1

Firmware Version: Archer AX6000(US)_V1_200714

I have tried to setup a new AX6000 at home, Things that i have tried

1.- Follow the quick step guide with Tether app

2.- Set the connection with browser 192.168.0.1

3.- Disconnect the modem and connecting it again after waiting a couple of minutes connecting the AX6000 to the LAN port of the modem and power it on

Im able to communicate with the router and even run speed test but still led is in red and internet connections says not available

1 Reply

Kevin_Z

2020-12-01 07:52:45

Posts: 21746

Helpful: 5122

Solutions: 2562

Stories: 21

Registered: 2018-12-24

Re:Red Led and no internet connection detected

2020-12-01 07:52:45

@BloNET

Is there a WAN IP address on the AX6000 after the configuration? If there is already an IP address, try to change the DNS server to 8.8.8.8 and 8.8.4.4, then reboot it and confirm.

If the internet LED is still orange, please follow the below instruction:
1. Unplug the modem’s power cord and unscrew the coaxial cable
2. Connect the modem to the Router’s WAN port and make sure the Router is powered on
3. Plug the power cord for the modem back in, but leave the coaxial cable disconnected.
4. Wait 3-5 minutes and reconnect the coaxial cable.
5. Wait for modem to reconnect and then check for IP and service.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Red Led and no internet connection detected

Red Led and no internet connection detected

Information

Voters 0

Tags