AX50/AX300, devices not showing up as Wireless Clients
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX50 in AccessPoint mode.
Many wifi devices are connected, but only 1 is shown in Status -> Wireless clients
have atleast 6 different android connected, not shown in the lists.. the only Windows client is listed.
Sounds like a defect?
Currently there is no way to list the devices connected to the AP.. poor management options!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I had the same issue for iOS devices not showing as Clients. I turned off Private Address setting in iOS and the clients appeared, as I do not want the MAC Randomization anyway. There is probably an equivalent setting in Android. I also tirned off SmartConnect on my AX-50 because it does not seem to do much anyway.
- Copy Link
- Report Inappropriate Content
Hi, that probably is because there is the data transmission is recorded when it is getting past through the access point, so it will not record the clients connected to the access point.
What I suggest is you can switch it to router mode just to confirm if this will display correctly, if yes, then I think there is no way to fix it.
- Copy Link
- Report Inappropriate Content
Wireless Clients should be always listed when they are connected via wifi, no difference if device is in router or AP mode.
- Copy Link
- Report Inappropriate Content
I had the same issue for iOS devices not showing as Clients. I turned off Private Address setting in iOS and the clients appeared, as I do not want the MAC Randomization anyway. There is probably an equivalent setting in Android. I also tirned off SmartConnect on my AX-50 because it does not seem to do much anyway.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1140
Replies: 3
Voters 0
No one has voted for it yet.