Home Network Community > Wi-Fi Routers > Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
< Wi-Fi Routers

Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2020-10-11 09:16:29 - last edited 2020-10-11 09:25:40
Model: Archer C80  
Hardware Version: V1
Firmware Version: 1.4.7 Build 200907 Rel.62218n (4555)

Regards to all,
I am using a Wi-Fi Router Archer C80 in Access Point Mode and since yesterday as I updated the new firmware 1.4.7 Build 200907 Rel.62218n (4555) there is a problem where in the setting in the section for Internet / Access Control there is no option for White List and is not visible, and only the Black List is visible.
On the previous firmware (Archer C80 (EU) _V1_200628) this problem does not exist and the White List and the Black List are visible!
Does anyone else have a similar problem?

File:
Access Control.jpgDownload
TRUST NO ONE, THE TRUTH IS OUT THERE!
  0      
 
  0      
 
#1
Options
7 Reply
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2020-10-15 17:12:22

@zexoni70 

Same FW and everything is OK.

  0  
  0  
#2
Options
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2020-10-15 17:41:10 - last edited 2020-10-15 19:58:46

Dear @PawelG123,

Is your version of the TP-Link Archer C80 for the European market or the USA?

 

I wrote to TP-Link support regarding this issue where they replied that the White List had been removed from the latest firmware because allegedly some users complained that it was causing problems and router crashes with earlier firmware versions.

Unfortunately, I didn't notice it in half a year of use.

 

You probably use the device in router mode, while I use it in Access point mode, so you have a White list in the settings! :)

Best regards.

File:
Access Point Mode.jpgDownload
TRUST NO ONE, THE TRUTH IS OUT THERE!
  0  
  0  
#3
Options
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2020-10-15 20:33:05

@zexoni70 

Yes, I have EU version, and it is in router mode.

  0  
  0  
#4
Options
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2021-01-28 19:38:24
Archer C80 1.0 with FW 1.4.9 Build 201003 Rel.55402n(4555)
 
 
EU version, Access Point mode:
 
 
 

 

Blacklist only is useless!

How / when will this be fixed?

  0  
  0  
#5
Options
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2021-01-29 02:03:16

@NET-Head 

 

Thank you for asking again.

 

As confirmed by zexoni70 that there is no whitelist for ACL when the C80 is working at AP mode. If you do need the whitelist feature, please change it to router mode.

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#6
Options
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2021-01-31 15:05:51

@Kevin_Z 

 

Thanks for the workaround, but no.

 

The C80 should fit into the existing network, not the other way round. I'm going to return the hardware for a refund.

 

I have got used to the older TL-WA-901ND as a fine piece of hard- and software, doing it's job without any problems for years.

 

Sadly, when reading through the support forum, it seems that tp-link has run into serious problems with their firmware development.

If there are problems with more or less usual features, it is likely that there hidden more problems and security flaws beneath the surface.

I have paid for the product, I will not beta test it.

 

Sorry for the harsh words, I know that this is not the supports fault or responsibility.

 

NET-Head

  1  
  1  
#7
Options
Re:Archer C80 problem with latest Firmware 1.4.7 Build 200907 Rel.62218n (4555) in Access Point Mode
2021-02-01 02:16:53

@NET-Head 

 

Thank you for your pertinent suggestion, we will take this into serious consideration and feedback to the development team.

 

If the current Archer C80 firmware cannot meet your needs, please return it to the store at your convenience.

 

Have a nice day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#8
Options

Information

Helpful: 0

Views: 2803

Replies: 7

Related Articles
Archer c80 problem
656 0
 Archer C80 the latest firmware Archer C80(EU)_V1_201003 cannot be updated
3498 0
Archer C80 - resets custom DNS servers after reboot with latest firmware (1.12.0)
524 1
Archer C80 WDS Problem - verliert Verbindung
754 0
 Problem... archer c80
487 0
On the latest firmware for Archer C80, the option "HTTP Referer Head Check" appeared in the setup
6410 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.