Bridge Mode does not reactive after reboot
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bridge Mode does not reactive after reboot
Hello, I am using my device in bridge Mode. It works successfully. However, if I power off and power on the device,automatically, it does not bridging again. I need to set PPPoE and set Bridge again on the web interface.
What is the solution to the problem?
Re:Bridge Mode does not reactive after reboot
Good day.
Sorry for the delay.
Did you enable the bridge mode on the 9970 like the attached picture?
If yes, but there is no need to set PPPoE for bridge connection?
If not, could you please provide more details about how do you use it as a bridge?
Or did you set 9970 wireless connected to another wireless router?
Thank you very much.
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller.
Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability.
TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.