VR2100 modem doesn’t recognize Archer C6 AP as OneMesh device
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a VR2100 as my modem/router, and a few Archer C6 in AP mode connected to it.
Although all are onemesh devices, the VR2100 does not recognize the C6 as a onemesh device.
why is that? How can I make it work?
Does smart connect has to be enabled on all devices for onemesh to work?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I now realize this is because the C6 APs are wire connected to the VR2100 router.
So onemesh doesn't work for wired APs? Any plan to change that?
- Copy Link
- Report Inappropriate Content
I now realize this is because the C6 APs are wire connected to the VR2100 router.
So onemesh doesn't work for wired APs? Any plan to change that?
- Copy Link
- Report Inappropriate Content
Good day.
Thank you very much for your time and patience.
Yes, you are right.
You can use a OneMesh™ Wireless Router or Modem Router with several sets of Range Extenders or Powerline Adapters to create a OneMesh™ network. Be aware, you cannot create a OneMesh™ network between two routers.
https://www.tp-link.com/onemesh/
and till now, we did not have the plan to add the OneMesh feature on access point mode;
Thank you very much!
- Copy Link
- Report Inappropriate Content
you are not reading my question correctly so let me rephrase:
Why does onemesh not work between a router and an AP when they are connected in a wired connection, and only when they are connected wirelessly? Why can't I use a wired connection for a onemesh backbone? Is there a plan to change that?
Thanks
ohad
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1285
Replies: 3
Voters 0
No one has voted for it yet.