Help please: Slave deco M4R keeps disconnecting- Pulsing RED light
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Facts:
-Using 2 deco M4R's for slightly more than a week and firmware is up to date.
-2 Deco M4's (both connected in router mode) and all on the same floor.\
-it has been really good for the last 1 week or so I have used it.
--from yesterday for no reason, slave deco keeps flashing red light every few seconds and drops connection.
-Now the main deco internet connection is intermittant too (one minute its fine and another minute it is not)
Trouble shooting steps undertaken:
1. Swapped places with main deco (unplugged from its bedroom location and plugged in place of main deco in the living room)
2. Reset the slave deco system.
These steps still did not solve the problem.
Can someone from TP Link look into see whats is causing the problerm urgently?
Response 1: Please see the screenshot below. App is same.
Response 2: Modem->Main Deco M4R (router mode) ->Slave deco (wifi)
Response 3: Main deco M4R is stable when the slaver deco showing pulsing red throughout yesterday.
Response 4: It pulses red every few minutes and I unplug and plug back the slave deco.
Response 5: No network change. It started suddenly from yesterday. I have already done a reboot and the routers are only slightly more than a week old.
Could you check my deco M4 logs to see what might be causing the issue?
