Using Deco M9 in Router mode with Plunet
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I cannot run the M9s in Router mode without double NAT using the Plusnet One modem/router as is connot be set in modem bridge mode. I cannot find details of a modem with 1000Mb port to use as a replacement. Can you advise?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
We may need to say sorry that we cannot give you a recommendation for the gigabit modems that can be configured into a bridge mode, as different ISPs may have different limitation or requirement, it is suggested to find an answer on Plusnet or modem forum, maybe they have an answer for you.
Sorry about that.
- Copy Link
- Report Inappropriate Content
Hello,
We may need to say sorry that we cannot give you a recommendation for the gigabit modems that can be configured into a bridge mode, as different ISPs may have different limitation or requirement, it is suggested to find an answer on Plusnet or modem forum, maybe they have an answer for you.
Sorry about that.
- Copy Link
- Report Inappropriate Content
@TP-Link_Deco can you tell me which Tp-link routers can be switched to modem only mode to avoid.double NAT with your M9 Decos?
- Copy Link
- Report Inappropriate Content
Hi, the TP-Link DSL modem routers can be changed to bridge mode, such as VR400 and VR600:
https://www.tp-link.com/uk/home-networking/dsl-modem-router/?filterby=5810
Below is the guide to configure it:
https://www.tp-link.com/support/faq/2728/
However, as I mentioned earlier, you need to confirm this with your ISP first and ensure they allow you to install a third-party modem on their line, otherwise, you may fail to use it.
Good day.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 971
Replies: 3
Voters 0
No one has voted for it yet.