Need help to fix my tp link extender RE200
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi ! I got a RE200 there's 2 weeks ago. It worked fine, until this morning. It looks like the extender doesnt give signal because I dont see its wifi's name anymore. All the lights are shining without exception, solid, and none of them are blinking or anything. I tried to reset it but... nothing happened, all the lights keep staying solid. The only way I can turn the lights off is when I unplug it but once I plug it again its still the same, all the lights are instantly solid. So, I cant connect to the extender, I cant reset it, and when I unplug and plug it, it becomes the same. What can I do to fix this problem ?
Good day.
Thank you very much for your time and patience.
For your case, please refer to the following suggestions：
- Hold the reset pinhole for 10s again to see if there is any difference:
- Still no, then fetch a cable connect the computed to the RE200, check if the computer get any IP address;
- Then try to log in via tplinkrepeater.net to see if you could see the web interface of RE200;
- If yes, please try to do the factory reset on the web UI;
By the way, where are you located?
Thank you very much.