DLNA Blocker with AX50 in Access Mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I got an AX50 and installed it in Access Mode with a variety of cable connection running through it. It replaced a D-link router that had been doing the same thing for years. The first thing that I noticed is that a DLNA server I have attached to it with a wire was not showing up on the network. There does not seem to be any settings in access mode that block or allow traffic. I "assumed" it should just act as an open switch.
Any ideas?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thank you @Kevin_Z
I just installed the new beta firmware, disabled IGMP Snooping and the NAS was instantly recognized by the TV in the AP Mode. When I enabled IGMP Snooping, the connection was lost again and the TV didn't recognize the DLNA Server anymore.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 6433
Replies: 42
Voters 0
No one has voted for it yet.